Inlet Manifold, Twin Port, Single pre-heat, 1300-1600cc, increased flow
Without a doubt the best manifold on the market for use with a standard 34 PICT carb and smaller 28/30PICT carbs (Flange has holes for both fitments). The casting looks far better than any of the other stock manifold on the market, plus the centre flows better than stock increasing performance. Both of the pre-heat tubes can be adjusted as they are a push fit in the casting rather than cast in place, making fitting the manifold a pleasure.
This Inlet Manifold Centre Section is designed to be used with 1600cc End Castings; item 050.317.10 for Twin Port items or item 444.009.11 for Single Port engines.
The threaded vacum port on the side of the manifold has an 1/8 NPT thread, suitable for our barbed fitting, see item 054.110.40.
Please note: The pre-heat pipes may require trimming to length as they are designed to fit both wide and standard engines.